Leviton Light Switch Removal

Remove pre cut insulation sleeves on each timer switch lead to expose bare wire strands.

Leviton light switch removal. 1 remove the wall plate using a flat head screwdriver then remove the old light switch from the wall box. 2 there should be three wires coming out of the wall box. Page 2 leviton manufacturing co inc att.

I am trying to replace a leviton nom 057 light switch with a dimmer switch. With aluminum wire use only devices marked co alr or cu al. Turn off the power supply to the room in which you are removing the lutron switch plate.

Using your pliers make a shephard s hook at the end of each wire. Adjust the light level adjustment toward lighter counterclockwise depending on room conditions. The switch es will turn the light on at the brightness level selected at the dimmer.

I want to replace and old leviton attic light switch with a leviton combo switch outlet. The two in have each a black wire going into to the push in terminals of the switch and one black one connected to a side screw going to the light. Single pole installation dia.

If it isn t turn one at a time off and check the room for power by trying to turn a light switch on. Bend back and forth to remove side section remove all inner side. This warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation.

Insulate end of yellow lead. Disconnect power at circuit breaker or fuse when servicing fixture. When i remove the old switch on the back of the switch i have a red and black wire connected to the two side terminals and another black connected to a pin in the center of the switch.