Leviton Light Switch Pairing Mode

Enter programming mode by holding the top of the paddle for 7 seconds the locator led will turn amber.

Leviton light switch pairing mode. The info you posted from smartthings got me going in the right direction. The three way switch is a variation of the standard single pole switch which controls a light only from one location. After turning off on the breaker and getting the light to turn amber i did get the switch be included into the system.

Push the switch back in and hold the bottom paddle it only has a bottom paddle until the light turns amber. The locator led is used to show the current state of the load. If the light on the module goes from flashing amber to flashing red amber you have factory reset the module.

When pairing your leviton devices press and hold the control button until the light begins flashing amber. Leviton decora smarttm z wave devices have a locator led on the bottom of the paddle. 1 you need to start pairing from the air gap position then push down and hold until it turns amber it will then be in pairing mode.

When pairing your leviton devices press and hold the control button until the light begins flashing amber. Just to reiterate to pair you push the top until the switch pops off. The operation of the led can be changed.

Then release the switch. My smartthings app found it almost immediately after doing that. We would like to show you a description here but the site won t allow us.

I did have the instruction sheet from leviton but that only has instructions for resetting it not putting it into pairing mode.